Seats; Replacing The Bearing Plate - Otto Bock B400 Service Manual

fig. 36 Replacing the bulbs of rear direction indicator and rear light
1 Direction indicator bulb
2 Rear light bulb

6.10 Seats

CAUTION
Risk of burns when near to fire. The backrest and seat of the B00 power wheelchair are flame
retardant but nevertheless flammable. Therefore utmost caution near any sources of open flame or
sparks, especially lit cigarettes, is required.
NOTICE
Risk of damage to the seat padding. When working on the seat, the padding must be sufficiently
protected against mechanical and chemical stresses.

6.10.1 Replacing the Bearing Plate

Tools:
Allen wrench, size  mm
❒
Ring wrench or open-end wrench, size 13 mm
❒
Steps:
1. Loosen the three Allen head screws marked with an arrow.
2. Remove and replace the bearing plate, if necessary.
The fourth screw in the middle of the plate serves as stop for the back angle adjust-
INfORMATION
ment.
2
1
2