Adjusting The Support Angle; Assembly C: Seat/Seating System; Replacing The Seat Plate; Replacing The Adaptable Seat Upholstery - Otto Bock Voyager Evo Service Manual

3.5.5.2 Adjusting the Support Angle

The footrest setting should be chosen so that the ankle is in a relaxed, comfortable position.
"Fixed" Footplate
The angle of the footplate cannot be changed (not illustrated).
"Angle-Adjustable" Footrest
1) Loosen the Allen head screws on the clamp bracket (see Fig. 20, item 1).
2) Rotate the footplate to the desired angle (see Fig. 20, item 2).
3) Tighten the Allen head screws to 10 Nm.
"Angle-Adjustable/Depth-Adjustable" Footrest
1) Remove the protective caps from the screw connection (see Fig. 19, item 3).
2) Loosen the Allen head screws above the footplate (not illustrated).
3) Rotate the footplate to the desired angle (see Fig. 19, item 4).
4) Tighten the Allen head screws to 10 Nm. Reinstall the protective caps.

3.6 Assembly C: Seat/Seating System

3.6.1 Replacing the Seat Plate

1) Loosen the Allen head screws on both sides (see Fig. 21, item 1).
2) Replace the seat plate.
3) Tighten the Allen head screws to 8 Nm.

3.6.2 Replacing the Adaptable Seat Upholstery

1) Pull the seat pad off the hook-and-loop fastener (see Fig. 26).
2) Remove the Allen head screws between the seat upholstery and frame (see Fig. 22, item 1).
3) Remove the seat upholstery.
4) If applicable: Remove the upholstery bars (see Fig. 23, item 1).
5) Install the new seat upholstery.
Voyager evo
20
21
Service Work
Ottobock | 13