7462
3. Remove the three screws (A) securing the HCIT controller card assembly.
A
4. Remove the HCIT controller card assembly and the shield.
High capacity input tray (HCIT) media size actuator assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT controller card assembly. See
assembly removal" on page
2. Disconnect the two springs (A) from the frame.
3. Slide the cam size sensing plate (B) through the access hole in the rear side frame.
A
4-170
Service Manual
"High capacity input tray (HCIT) controller card
4-169.
B
Previous
Next
Go Back