Modulator/Coder Configuration Program - Comtech EF Data SDM-650B Installation And Operation Manual

Remote Control Operation
B.2.8.1.2 Modulator/Coder Configuration Program
This command is used by the SMS-658 M:N protection switch to collect information that
is necessary to configure backup modems.
Command:
Response:
(See Note 1)
(See Note 2)
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 1)
Notes:
1. Available with AUPC support hardware only.
2. Only returned if local AUPC is disabled (OFF).
B–56
<add/MCP_"cr"
>add/MCP_"cr"
MF_nnn.nnnn"cr"
MPO_snn.n"cr"
LPC_xxx"cr"
MOP_snn.n"cr"
MR_nnn_mmmm.m"cr"
SE_xxx"cr"
DENC_xxx"cr"
TC_xxx"cr"
BBL_xxx"cr"
ILB_xxx"cr"
ICFT_xxxx"cr"
TOBR_nnnnn"cr"
OCCL_n"cr"
OCSB_n"cr"
OCP_xxxx"cr"
ISP_xxx"cr"
LPC_xxx"cr"
NOMP_-nn.n"cr"
MINP_-nn.n"cr"
MAXP_-nn.n"cr"
LCL_xxxx"cr"
RCL_xxxx"cr"
RF_xxx"cr""lf"]
SDM-650B Satellite Modem
Modulator Frequency
Modulator Power Offset
Local AUPC Enable (ON/OFF)
Modulator Output Power
Modulator Rate
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Transmit Clock (INT/EXT)
Baseband Loopback (ON/OFF)
Interface Loopback (ON/OFF)
Coding Format Transmit
(AMI/HDB3/B6ZS/B8ZS)
Transmit Overhead Baud Rate
Overhead Channel Character Length
Overhead Channel Stop Bits
Overhead Channel Parity
Interface Substitution Pattern 2047 (ON/OFF)
Local AUPC Enable (ON/OFF)
Nominal Power Value (-5.0 to -30.0)
Minimum Power Limit (-5.0 to -30.0)
Maximum Power Value (-5.0 to -30.0)
Local Carrier Loss (HOLD, NOM, MAX)
Remote Carrier Loss (HOLD, NOM, MAX)
RF Output (ON/OFF)
Rev. 6