Bulk Consolidated Analog Status - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem
(See Note 1)
Notes:
1. Available with buffer support hardware only.
2. Parameters 23, 24, and 25 are only returned when fast acquisition is enabled. See
B.2.8.18 Bulk Consolidated Analog Status
This command is similar to the "BCS_" command, but returns modem analog parameters.
Command:
Response:
(See Notes)
Notes:
1. Parameters 1 through 5 are dependent on carrier acquisition. If the decoder is not
2. Available with buffer support hardware only.
Rev. 6
Parameter 40 (p40): Interface buffer size.
p40 = nnnnnn, where "nnnnnn" is the currently programmed buffer size in bits.
the "FAM_" command definition.
<add/BCAS_"cr"
>add/BCAS_p1,p2,p3, . . . pn"cr""lf"]
Where: "pn" is the last parameter returned.
Parameter 1 (p1): Receive signal level.
p1 = -nn, where "nn" is the value of the receive signal level in dBm.
Parameter 2 (p2): Raw BER.
p2 = nnnnE-4, where "nnnn" is the raw bit errors in 10000 bits.
Parameter 3 (p3): Corrected BER.
p3 = nE-e, where "n" is the mantissa, and "e" is exponent (power of 10).
Parameter 4 (p4): E /N
b
p4 = n.n, where "n.n" is E
Parameter 5 (p5): Interface Buffer Fill Status.
p5 = nn, where "nn" is the fill status in percent.
locked, empty data blocks are returned (,,,,,).
.
0
/N in dB.
b 0
Remote Control Operation
B–69