Comtech EF Data SDM-650B Installation And Operation Manual page 330

Trojan Interface
G.6.4.5.1.4 Demodulator/Decoder Configuration Program
This command is used by the SMS-658 or SMS-758 M:N protection switch to collect
information that is necessary to configure back-up modems.
Command:
Response:
Note: "SCF_", "SWR_", and "SD_" responses are returned only when fast acquisition is
enabled. See the "FAM_" command definition.
G.6.4.5.1.5 Interface Configuration Status
This command causes a block of data to be returned by the addressed modem. The block
reflects the current configuration of the interface.
Command:
Response:
G–34
<add/DCP_"cr"
>add/DCP_"cr"
IFL_xxx"cr"
RFL_xxx"cr"
DF_nnn.nnnn"cr"
DR_nnn_mmmm.m"cr"
DE_xxx"cr"
BERT_xxxx"cr"
SR_xxx"cr"
BBL_xxx"cr"
RC_xxx"cr"
ERF_nnnnn"cr"
IRC_xxx"cr"
IBD_nnnnn"cr"
FAM_xxx"cr"
SCF_snnnnn"cr"
SWR_nnnnn"cr"
SD_s"cr""lf"]
<add/ICS_"cr"
>add/ICS_"cr"
BBL_xxx"cr"
TC_xxx"cr"
RC_xxx"cr"
ERF_nnnnn"cr"
IRC_xxx"cr"
IBD_nnnnn"cr""lf"]
SDM-650B Satellite Modem
IF loopback (ON/OFF)
RF loopback (ON/OFF)
Demodulator frequency
Demodulator data rate
Descrambler enable (ON/OFF)
BER Threshold
Sweep Reacquisition (seconds)
Baseband Loopback
Receive Clock (INV/NRM)
External Reference Frequency (kHz)
Interface Reference Clock source
(TXC/RXC/EXT/INT)
Interface Buffer Depth (in bits)
Fast Acquisition Mode
Sweep Center Frequency
Sweep Width
Sweep Direction
Base Band Loopback (ON/OFF)
Transmit Clock (REF/EXT)
Receive Clock (INV/NRM)
External Reference Frequency (kHz)
Interface Reference Clock source
(TXC/RXC/EXT/INT)
Interface Buffer Depth (in bits)
Rev. 5