Comtech EF Data SDM-650B Installation And Operation Manual page 336

Trojan Interface
G.6.4.5.13 Bulk Consolidated Status
This command causes bulk modem status to be returned. To reduce the length of the
response, message parameter data are returned without identifiers. However, parameter
identification can be determined by order of return. Each status parameter is terminated with
a "," (comma), except for the last parameter which has the standard message termination
sequence ("cr""lf"]). For standardization reasons, some parameters may not be
implemented but will retain the terminating "," (comma). Most of the data returned is
formatted the same way as the single command status request (refer to the appropriate
portions of this document in preceding sections).
Command:
Response:
G–40
<add/BCS_"cr"
>add/BCS_p1,p2,p3, . . . pn"cr""lf"]
Where: pn =
Parameter 1 (p1): Modulator RF output ON/OFF.
p1 = n, where "n" is "0" to indicate off or "1" to indicate on.
Parameter 2 (p2): Modulator IF frequency.
p2 = nnnn.nnnn, where "nnnn.nnnn" is the modulator IF frequency in MHz.
Parameter 3 (p3): Modulator output power level.
p3 = snn.n, where "snn.n" is the transmitter output power level in dBm.
Parameter 4 (p4): Modulator rate currently programmed.
p4 = nnn_mmmm.m, where "nnn" is the code rate, and "mmmm.m" is the data rate in
kbit/s.
Parameter 5 (p5): Modulator filter A assignment.
p5 = nnn_mmmm.m, where "nnn" is the code rate, and "mmmm.m" is the data rate in
kbit/s.
Parameter 6 (p6): Modulator filter B assignment.
p6 = nnn_mmmm.m, where "nnn" is the code rate and "mmmm.m" is the data rate in
kbit/s.
Parameter 7 (p7): Modulator filter C assignment.
p7 = nnn_mmmm.m, where "nnn" is the code rate, and "mmmm.m" is the data rate in
kbit/s.
Parameter 8 (p8): Modulator filter D assignment.
p8 = nnn_mmmm.m, where "nnn" is the code rate, and "mmmm.m" is the data rate in
kbit/s.
Parameter 9 (p9): Scrambler enable ON/OFF.
p9 = n, where "n" is "0" to indicate off or "1" to indicate on.
Parameter 10 (p10): Carrier only mode ON/OFF.
p10 = n, where "n" is "0" to indicate off or "1" to indicate on.
Parameter 11 (p11): Differential encoder enable ON/OFF.
p11 = n, where "n" is "0" to indicate off or "1" to indicate on.
Parameter 12 (p12): Transmit clock source (Reference/External).
p12 = n, where "n" is "0" or "1" ("0" = REF, "1" = EXT).
Parameter 13 (p13): Demodulator IF frequency.
p13 = nnnn.nnnn, where "nnnn.nnnn" is the demodulator IF frequency in MHz.
Parameter 14 (p14): Demodulator rate currently programmed.
p14 = nnn_mmmm.m, where "nnn" is the code rate, and "mmmm.m" is the data rate in
kbit/s.
SDM-650B Satellite Modem
Rev. 5