Status Commands/Responses; Configuration; Modulator/Coder Status; Modulator/Coder Program - Comtech EF Data SDM-650B Installation And Operation Manual

Remote Control Operation
B.1.4. Status Commands/Responses
B.1.4.1 Configuration
B.1.4.1.1 Modulator/Coder Status
The Modulator/Coder configuration status command causes a block of data to be returned
by the addressed modem. The block of data reflects the current configuration status of the
Modulator/Coder.
Command:
Response:
B.1.4.1.2 Modulator/Coder Program
This command is used by the SMS-658 M:N protection switch to collect information that
is necessary to configure backup modems.
Command:
Response:
B–18
<add/MCS_"cr"
>add/MCS_"cr"
RF_xxx"cr"
MF_nnn.nnnn"cr"
MPO_snn.n"cr"
MOP_snn.n"cr"
MR_nnn_mmmm.m"cr"
AMRA_nnn_mmmm.m"cr"
AMRB_nnn_mmmm.m"cr"
AMRC_nnn_mmmm.m"cr"
AMRD_nnn_mmmm.m"cr"
SE_xxx"cr"
COM_xxx"cr"
DENC_xxx"cr"
TC_xxx"cr"
AMRV_nnn.mmmm.m"cr""lf"]
<add/MCP_"cr"
>add/MCP_"cr"
MF_nnn.nnnn"cr"
MPO_snn.n"cr"
MOP_snn.n"cr"
MR_nnn_mmmm.m"cr"
SE_xxx"cr"
DENC_xxx"cr"
TC_xxx"cr"
RF_xxx"cr""lf"]
SDM-650B Satellite Modem
RF Output (ON/OFF)
Modulator Frequency
Modulator Power Offset
Modulator Output Power
Modulator Rate
Filter "A" Assignment
Filter "B" Assignment
Filter "C" Assignment
Filter "D" Assignment
Scrambler Enable (ON/OFF)
Carrier Only Mode (ON/OFF)
Differential Encoder (ON/OFF)
Transmit Clock (INT/EXT)
Modulator Variable Rate Assignment
(Variable Rate Option Only)
Modulator Frequency
Modulator Power Offset
Modulator Output Power
Modulator Rate
Scrambler Enable (ON/OFF)
Differential Encoder (ON/OFF)
Transmit Clock (INT/EXT)
RF Output (ON/OFF)
Rev. 6