Demodulator/Decoder Configuration Program; Modem Faults Status (Summary - Comtech EF Data SDM-650B Installation And Operation Manual

Remote Control Operation
B.1.4.1.4 Demodulator/Decoder Configuration Program
This command is used by the SMS-658 M:N protection switch to collect information that
is necessary to configure backup modems.
Command:
Response:
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 2)
(See Note 2)
Notes:
1. "SCF_", "SWR_", and "SD_" responses are returned only when fast acquisition
2. "BC_" and "IBS_" responses are returned only when Buffer Control is enabled.
B.1.4.2 Modem Faults Status (Summary)
This command returns the current overall fault conditions of the modem.
Command:
Response:
(See Note)
Note: "IRX_" response is returned only when Buffer Control is enabled. See the
"BUFF_" command definition.
B–20
<add/DCP_"cr"
>add/DCP_"cr"
BBL_xxx"cr"
IFL_xxx"cr"
RFL_xxx"cr"
DF_nnn.nnnn"cr"
DR_nnn_mmmm.m"cr"
DE_xxx"cr"
RC_xxx"cr"
BERT_xxxx"cr"
SR_xxx"cr"
FAM_xxx"cr"
SCF_snnnnn"cr"
SWR_nnnnn"cr"
SD_s"cr"
BC_xxx"cr"
IBS_nnnnn"cr""lf"]
is enabled. See the "FAM_" command definition.
See the "BUFF_" command definition.
<add/MFS_"cr"
>add/MFS_"cr"
DMD_xxx"cr"
MOD_xxx"cr"
CEQ_xxx"cr"
IRX_xxx"cr""lf"]
SDM-650B Satellite Modem
Baseband Loopback (ON/OFF)
IF Loopback (ON/OFF)
RF Loopback (ON/OFF)
Demodulator Frequency
Demodulator Data Rate
Descrambler Enable (ON/OFF)
Receive Clock (NRM/INV)
BER Threshold
Sweep Reacquisition (seconds)
Fast Acquisition Mode
Sweep Center Frequency
Sweep Width
Sweep Direction
Buffer Clock Source
Interface Buffer Size
Demodulator (FLT/OK)
Modulator (FLT/OK)
Common Equipment (FLT/OK)
Interface Receive Side (FLT/OK)
Rev. 6