Comtech EF Data SDM-650B Installation And Operation Manual page 329

SDM-650B Satellite Modem
G.6.4.5.1.2 Modulator/Coder Configuration Program
This command is used by the SMS-658 or SMS-758 M:N protection switch to collect
information that is necessary to configure back-up modems.
Command:
Response:
G.6.4.5.1.3 Demodulator/Decoder Configuration Status
The Demodulator/Decoder configuration status command causes a block of data to be
returned by the addressed modem. The block of data reflects the current configuration of the
demod.
Command:
Response:
Note: "SCF_", "SWR_", and "SD_" responses are returned only when Fast Acquisition is
enabled. See the "FAM_" command definition.
Rev. 5
<add/MCP_"cr"
>add/MCP_"cr"
MF_nnn.nnnn"cr"
MPO_snn.n"cr"
MOP_snn.n"cr"
MR_nnn_mmmm.m"cr"
SE_xxx"cr"
DENC_xxx"cr"
BBL_xxx"cr"
TC_xxx"cr"
ERF_nnnnn"cr"
IRC_xxx"cr"
RF_xx"cr""lf"]
<add/DCS_"cr"
>add/DCS_"cr"
DF_nnn.nnnn"cr"
DR_nnn_mmmm.m"cr"
ADRA_nnn_mmmm.m"cr"
ADRB_nnn_mmmm.m"cr"
ADRC_nnn_mmmm.m"cr"
ADRD_nnn_mmmm.m"cr"
DE_xxx"cr"
RC_xxx"cr"
BBL_xxx"cr"
RFL_xxx"cr"
BERT_xxxx"cr"
SR_xxx"cr"
IFL_xxx"cr"
SCF_snnnnn"cr"
SWR_nnnnn"cr"
SD_s"cr"
FAM_xxx"cr"
ADRV_nnn.mmmm.m"cr""lf"]
Modulator frequency
Modulator Power Offset
Modulator Output Power
Modulator rate
Scrambler enable (ON/OFF)
Differential encoder (ON/OFF)
Baseband Loopback
Transmit Clock (REF/EXT)
External Reference Frequency (kHz)
Interface Reference Clock source
(TXC/RXC/EXT/INT)
RF output
Demodulator frequency
Demodulator data rate
Filter "A" assignment
Filter "B" assignment
Filter "C" assignment
Filter "D" assignment
Descrambler enable (ON/OFF)
Receive clock (NRM/INV)
Baseband loopback (ON/OFF)
RF loopback (ON/OFF)
BER Threshold
Sweep Reacquisition (seconds)
IF loopback (ON/OFF)
Sweep Center Frequency
Sweep Width
Sweep Direction
Fast Acquisition Mode
Demodulator variable rate assignment
(variable rate option only)
Trojan Interface
G–33