Comtech EF Data SDM-650B Installation And Operation Manual page 323

SDM-650B Satellite Modem
G.6.4.2.9 Sweep Width Range
This command sets the overall travel of the sweep during acquisition. The sweep width may
be set in the range of 0 to 50000 Hz.
Command:
Response:
Status Only:
Response:
Note: This command is only valid when Fast Acquisition is enabled. See the "FAM_"
command definition.
G.6.4.2.10 Sweep Direction
This command sets the direction of the sweep travel. "+" sets incremental sweep, while "-"
sets decremental sweep.
Command:
Response:
Status Only:
Response:
Note: This command is only valid when Fast Acquisition is enabled. See the "FAM_"
command definition.
G.6.4.2.11 Bit Error Rate Threshold
Command:
Response:
Status Only:
Response:
Rev. 5
<add/SWR_nnnnn"cr"
>add/SWR_nnnnn"cr""lf"]
<add/SWR_"cr"
>add/SWR_nnnnn"cr""lf"]
Where: nnnnn = 0 to 50000.
<add/SD_s"cr"
>add/SD_s"cr""lf"]
<add/SD_"cr"
>add/SD_s"cr""lf"]
Where: s = + or - (direction of sweep travel during acquisition).
<add/BERT_xxxx"cr"
>add/BERT_xxxx"cr""lf"]
<add/BERT_"cr"
>add/BERT_xxxx"cr""lf"]
Where: xxxx = NONE or 1E-n (n = 3, 4, 5, 6, 7, or 8 [exponent of threshold]).
Trojan Interface
G–27