Remote Baud Rate - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem

3.1.1.2 Remote Baud Rate

The remote communications baud rate and parity are programmed by a switch pack (SP1)
on the M&C module.
Programming the baud rate and parity is accomplished by setting the appropriate switches
in the OFF or ON positions:
•
•
Switch position #1 sets the parity as follows:
Even Parity
Odd Parity
Switch positions #2, #3, and #4 set the baud rate as follows:
Note: SP1 on the M&C modules has four additional switches (SP1-5 through SP1-8).
These four switch locations are not currently assigned or used.
Rev. 5
A switch is programmed OFF by placing it in the position furthest away from the
PCB (open).
A switch is programmed ON by placing it in the position nearest the PCB.
SP1-1
SP1-1
Baud SP1-2 SP1-3
110 ON ON
150 ON ON
300 ON OFF
600 ON OFF
1200 OFF ON
2400 OFF ON
4800 OFF OFF
9600 OFF OFF
OFF
ON
SP1-4
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Configuration
3–3