SDM-650B Satellite Modem
G.6.4.2.3 Descramble Enable
Command:
Response:
Status Only:
Response:
G.6.4.2.4 IF Loopback
Command:
Response:
Status Only:
Response:
G.6.4.2.5 RF Loopback
Command:
Response:
Status Only:
Response:
G.6.4.2.6 Sweep Reacquisition
This command is used to specify time duration of the reacquisition mode. The sweep is
reduced to
reacquisition times at low data rates. To inhibit the sweep reacquisition mode, set "SR" to 0
seconds.
Command:
Response:
Status Only:
Response:
Rev. 5
<add/DE_xxx"cr"
>add/DE_xxx"cr""lf"]
<add/DE_"cr"
>add/DE_xxx"cr""lf"]
Where: xxx = ON or OFF.
<add/IFL_xxx"cr"
>add/IFL_xxx"cr""lf"]
<add/IFL_"cr"
>add/IFL_xxx"cr""lf"]
Where: xxx = ON or OFF.
<add/RFL_xxx"cr"
>add/RFL_xxx"cr""lf"]
<add/RFL_"cr"
>add/RFL_xxx"cr""lf"]
Where: xxx = ON or OFF.
2500 Hz of the last known lock point. Use of this function may reduce
±
<add/SR_xxx"cr"
>add/SR_xxx"cr""lf"]
<add/SR_"cr"
>add/SR_xxx"cr""lf"]
Where: xxx = 0 to 999 (number of seconds).
Trojan Interface
G–25