Interface Configuration Status; Aupc Configuration Status - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem
B.2.8.1.5 Interface Configuration Status
The interface configuration status command causes a block of data to be returned by the
addressed modem. The block reflects the current configuration of the interface.
Command:
Response:
(See Note 2)
(See Note 1)
(See Note 1)
(See Note 1)
Notes:
1. Available with buffer support hardware only.
2. Available with AUPC support hardware only.
B.2.8.1.6 AUPC Configuration Status
The AUPC interface configuration status command causes a block of data to be returned
by the addressed modem. The block reflects the current configuration of the interface.
Command:
Response:
Rev. 6
<add/ICS_"cr"
>add/ICS_"cr"
TC_xxx"cr"
RC_xxx"cr"
BBL_xxx"cr"
ILB_xxx"cr"
ICFT_xxxx"cr"
ICFR_xxxx"cr"
TOBR_nnnnn"cr"
ROBR_nnnnn"cr"
OCCL_n"cr"
OCSB_n"cr"
OCP_xxxx"cr"
ISP_xxx"cr"
ERF_nnnnn"cr"
BC_xxx"cr"
IBS_nnnnnn"cr""lf"]
<add/ACS_"cr"
>add/ACS_"cr"
LPC_xxx"cr"
NOMP_-nn.n"cr"
MINP_-nn.n"cr"
MAXP_-nn.n"cr"
ENSP_n.n"cr"
MAXT_n.n"cr"
LCL_xxxx"cr"
RCL_xxxx"cr"
ISP_xxx"cr""lf"]
Remote Control Operation
Transmit Clock (INT/EXT)
Receive Clock (NRM/INV)
Baseband Loopback (ON/OFF)
Interface Loopback (ON/OFF)
Coding Format Transmit
(AMI/HDB3/B6ZS/B8ZS)
Coding Format Receive
(AMI/HDB3/B6ZS/B8ZS)
Transmit Overhead Baud Rate
Receive Overhead Baud Rate
Overhead Channel Character Length
Overhead Channel Stop Bits
Overhead Channel Parity
Interface Substitution Pattern 2047 (ON/OFF)
External Reference Frequency
Buffer Clock (INT, EXT, REF, SAT)
Interface Buffer Size
Local AUPC Enable (ON/OFF)
Nominal Power Value (-5.0 to -30.0)
Minimum Power Limit (-5.0 to -30.0)
Maximum Power Value (-5.0 to -30.0)
E /N Target Set Point (3.2 to 9.7)
b 0
Max. Tracking Rate (0.5 to 6.0)
Local Carrier Loss (HOLD, NOM, MAX)
Remote Carrier Loss (HOLD, NOM, MAX)
Interface Substitution Pattern 2047 (ON/OFF)
B–59