Modem Operation Mode; Automatic Uplink Power Control (Aupc) Configuration Commands; Local Modem Aupc Commands; Local Aupc Enable - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem
B.2.6.5 Modem Operation Mode
This command configures the modem for simplex or duplex operation modes.
When transmit-only mode is selected, receive faults are inhibited. When receive-only
mode is selected, transmit faults are inhibited.
Command:
Response:
Status Only: <add/MOM_"cr"
Response:
B.2.7 Automatic Uplink Power Control (AUPC) Configuration Commands
B.2.7.1 Local Modem AUPC Commands
B.2.7.1.1 Local AUPC Enable
Command:
Response:
Status Only: <add/LPC_"cr"
Response:
Note: When programmed ON, the MOP command is not allowed; only MOP status is
allowed.
B.2.7.1.2 Nominal AUPC Power Level
Command:
Response:
Status Only: <add/NOMP_"cr"
Response:
Rev. 6
<add/MOM_xxxxxxx"cr"
>add/MOM_xxxxxxx"cr""lf"]
>add/MOM_xxxxxxx"cr""lf"]
Where: xxxxxxx = TX_ONLY, RX_ONLY, or DUPLEX.
<add/LPC_xxx"cr"
>add/LPC_xxx"cr""lf"]
>add/LPC_xxx"cr""lf"]
Where: xxx = ON or OFF (local AUPC enable).
<add/NOMP_-nn.n"cr"
>add/NOMP_-nn.n"cr""lf"]
>add/NOMP_-nn.n"cr""lf"]
Where: nn.n = 5.0 to 30.0, in 0.5 increments (power in dBm).
Remote Control Operation
B–51