Comtech EF Data SDM-650B Installation And Operation Manual page 334

Trojan Interface
G.6.4.5.9 Demodulator Rate
Command:
Response:
Note: The parameters "nnn_mmmm.m" may be replaced by "N/A" to indicate "no
assignment."
G.6.4.5.10 Receive Signal Level
Command:
Response:
G.6.4.5.11 Current Sweep Value
This command returns the current sweep value and the decoder lock status.
Command:
Response:
G.6.4.5.12 Stored Faults
Information on stored faults is returned when requested. If no stored fault exists for a given
fault number, the words "No Fault" will be returned instead of the normal time/date status
information.
The following symbols are commonly used to define the stored faults status commands:
•
•
•
•
•
•
•
G–38
<add/DR_"cr"
>add/DR_nnn_mmmm.m"cr""lf"]
Where:
nnn = 1/2, 3/4, 7/8, or BP12 (Coder rate).
mmmm.m = 9.6 to 4080.0 (Data rate).
<add/RSL_"cr"
>add/RSL_-nn.ndBm"cr""lf"]
<add/CSV_"cr"
>add/CSV_snnnnn"cr"
CD_xxx"cr""lf"]
Where:
s = + or - (sweep offset direction).
nnnnn = 0 to 25000.
xxx = OK or FLT (decoder lock status OK or FAULT).
# Fault number (0 to 9), "0" is the first fault stored.
hh Hours in 24-hour format.
mm Minutes.
ss Seconds.
MM Month.
DD Day.
YY Year.
SDM-650B Satellite Modem
Rev. 5