Demodulator/Decoder Configuration Program - Comtech EF Data SDM-650B Installation And Operation Manual

Remote Control Operation
B.2.8.1.4 Demodulator/Decoder Configuration Program
This command is used by the SMS-658 M:N protection switch to collect information that
is necessary to configure backup modems.
Command:
Response:
(See Note 2)
(See Note 2)
(See Note 2)
(See Note 1)
(See Note 1)
(See Note 1)
(See Note 3)
(See Note 3)
Notes:
1. Available with buffer support hardware only.
2. "SCF_", "SWR_", and "SD_" responses are returned only when fast acquisition
3. Available with AUPC support hardware only.
B–58
<add/DCP_"cr"
>add/DCP_"cr"
IFL_xxx"cr"
RFL_xxx"cr"
DF_nnn.nnnn"cr"
DR_nnn_mmmm.m"cr"
DE_xxx"cr"
BERT_xxxx"cr"
SR_xxx"cr"
FAM_xxx"cr"
SCF_snnnnn"cr"
SWR_nnnnn"cr"
SD_s"cr"
RC_xxx"cr"
BBL_xxx"cr"
ILB_xxx"cr"
ICFR_xxxx"cr"
ROBR_nnnnn"cr"
OCCL_n"cr"
OCSB_n"cr"
OCP_xxxx"cr"
ERF_nnnnn"cr"
BC_xxx"cr"
IBS_nnnnnn"cr"
ENSP_n.n"cr"
MAXT_n.n"cr""lf"]
is enabled. See the "FAM_" command definition.
SDM-650B Satellite Modem
IF Loopback (ON/OFF)
RF Loopback (ON/OFF)
Demodulator Frequency
Demodulator Data Rate
Descrambler Enable (ON/OFF)
BER Threshold
Sweep Reacquisition (seconds)
Fast Acquisition Mode
Sweep Center Frequency
Sweep Width
Sweep Direction
Receive Clock (NRM/INV)
Baseband Loopback (ON/OFF)
Interface Loopback (ON/OFF)
Coding Format Receive
(AMI/HDB3/B6ZS/B8ZS)
Receive Overhead Baud Rate
Overhead Channel Character Length
Overhead Channel Stop Bits
Overhead Channel Parity
External Reference Frequency
Buffer Clock (INT/EXT/SAT/REF)
Interface Buffer Size
E /N Target Set Point (3.2 to 9.7)
b 0
Max. Tracking Rate (0.5 to 6.0)
Rev. 6