Demodulator/Decoder Configuration Status - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem
B.2.8.1.3 Demodulator/Decoder Configuration Status
The Demodulator/Decoder configuration status command causes a block of data to be
returned by the addressed modem. The block of data reflects the current configuration of
the demod.
Command:
Response:
(See Note)
(See Note)
(See Note)
Note: "SCF_", "SWR_", and "SD_" responses are returned only when fast acquisition is
enabled. See the "FAM_" command definition.
Rev. 6
<add/DCS_"cr"
>add/DCS_"cr"
DF_nnn.nnnn"cr"
DR_nnn_mmmm.m"cr"
ADRA_nnn_mmmm.m"cr"
ADRB_nnn_mmmm.m"cr"
ADRC_nnn_mmmm.m"cr"
ADRD_nnn_mmmm.m"cr"
DE_xxx"cr"
RFL_xxx"cr"
BERT_xxxx"cr"
SR_xxx"cr"
IFL_xxx"cr"
SCF_snnnnn"cr"
SWR_nnnnn"cr"
SD_s"cr"
FAM_xxx"cr"
ADRV_nnn.mmmm.m"cr""lf"]
Remote Control Operation
Demodulator Frequency
Demodulator Data Rate
Filter "A" Assignment
Filter "B" Assignment
Filter "C" Assignment
Filter "D" Assignment
Descrambler Enable (ON/OFF)
RF Loopback (ON/OFF)
BER Threshold
Sweep Reacquisition (seconds)
IF Loopback (ON/OFF)
Sweep Center Frequency
Sweep Width
Sweep Direction
Fast Acquisition Mode
Demodulator Variable Rate Assignment
(Variable Rate Option Only)
B–57