Comtech EF Data SDM-650B Installation And Operation Manual page 318

Trojan Interface
G.6.4.1.3.5 Set Modulator Output Power Level
Command:
Response:
Status Only: <add/MOP_"cr"
Response:
Notes:
1. Power levels may be programmed for a maximum value specified by the
2. See the "MPO_" command specification for more information.
G.6.4.1.3.6 Scrambler Enable
Command:
Response:
Status Only: <add/SE_"cr"
Response:
G.6.4.1.3.7 Differential Encoder Enable
Command:
Response:
Status Only: <add/DENC_"cr"
Response:
G–22
<add/MOP_snn.n"cr"
>add/MOP_snn.n"cr""lf"]
>add/MOP_snn.n"cr""lf"]
Where:
For the 140 MHz modulator, snn.n = +20.0 to -45.0, in 0.5 dB increments.
For the 70 MHz modulator, snn.n = +20.0 to -30.0, in 0.5 dB increments.
modulator power, offset with a range of 25 and 10 dB below the maximum value
for the 140 MHz modulator and the 70 MHz modulator, respectively.
<add/SE_xxx"cr"
>add/SE_xxx"cr""lf"]
>add/SE_xxx"cr""lf"]
Where: xxx = ON or OFF.
<add/DENC_xxx"cr"
>add/DENC_xxx"cr"lf"]
>add/DENC_xxx"cr"lf"]
Where: xxx = ON or OFF.
SDM-650B Satellite Modem
Rev. 5