B.4 Status Commands/Responses; B.4.1 Modulator Configuration Status - Comtech EF Data SNM-1001L Installation And Operation Manual

SNM-1001L Satellite Modem
Remote Control Operation
Remote Command:
Interface Response:
Read Error Example:
Status Command:
Response:

B.4 Status Commands/Responses

B.4.1 Modulator Configuration Status

Modulator Command:
Config. Response:
Status
<add/RRES_'cr'
>add/RRES_nE-e'cr''lf']
<add/RRES_'cr'
>add/RRES_2E-6'cr''lf']
<add/MCS_'cr'
>add/MCS_'cr'
RF_xxx'cr'
MF_nnn.nnnnnnn'cr'
MF_nnnnn.nnnn'cr'
MR_nnnn_mmmm.mmm'cr'
AMRA_nnnn_mmmm.mmm'cr'
AMRB_nnnn_mmmm.mmm'cr'AM
RC_nnnn_mmmm.mmm'cr'
AMRD_nnnn_mmmm.mmm'cr'
AMRV_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxxx'cr'
MET_xxx'cr'
COM_xxxxxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
TRSI_xx'cr'
T310_xxx'cr'
ODU_xxx'cr' (Note 1)
ODUR_xxx'cr' (Note 1)
ODUL_xxxx'cr' (Note 1)
ODUH_xxxx'cr''lf'] (Note 1)
Where:
n = 1 to 9 (error rate number).
e = 2 to 6 (exponent).
Notes:
1. Received 2047 Pattern.
2. AYNC or AUPC Overhead only.
This command returns 2047 BER from the remote AUPC
modem. If data is not valid, the message 'No_Data' is
returned in lieu of BER data.
RF Output
Modulator Frequency (Non L-Band modem)
Modulator Frequency (Non L-Band modem)
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Type
Modulator Encoder Type
Carrier Only Mode
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
TX Reed-Solomon Interleave Value
TX 8PSK 2/3 IESS-310 Operation
ODU Power
ODU Reference
ODU Current Monitor Low Current Threshold
ODU Current Monitor High Current Threshold
The modulator configuration status command causes a block
of data to be returned by the addressed modem. The block of
data reflects the current configuration status of the modulator
module. Additional configuration status of new options and
features will always be appended to the end.
Notes
1. Data is only returned for the TX/RF L-Band modem.
B–14
Revision 1
MN/SNM1001L.IOM