NEC Univerge SV8100 Features And Specifications Manual page 1235

UNIVERGE SV8100
Program
Program Name
Number
20-03-03 System Options for Single Line
Telephones – SLT DTMF Dial to
Trunk Lines
20-03-04 System Options for Single Line
Telephones – Dial Sending Start
Time for SLT or ARS
20-03-05 System Options for Single Line
Telephones – SLT Operation
Mode
20-03-06 System Options for Single Line
Telephones – Headset Ringing
Start Time (for SLT)
20-03-07 System Options for Single Line
Telephones – Trunk Call Dial
Forced Sending Start Time
(Forced Dial)
20-06-01 Class of Service for Extensions
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
20-15-01 Ring Cycle Setup – Normal
Incoming Call on Trunk
20-15-03 Ring Cycle Setup – Incoming
Internal Call
20-15-05 Ring Cycle Setup – DID/DDI
Single Line Telephones, Analog 500/2500 Sets
Description/Comments
Set the SLT phones to (0). Collect
all digits before sending or (1),
send out immediately after
receiving. When using a
third-party external paging device,
set this option to 1. In addition, set
Program 20-03-04 to 1.
Set the time before the first digit is
sent out. When using a third-party
external paging device, set this
option to 1. In addition, set
Program 20-03-03 to 1.
Define the Operation Mode for
SLT terminals.
Define the headset ringing start
time. After this time expires from
the time when a single line
telephone is off-hook, the system
sets the single line telephone to
headset ringing mode.
Define the Trunk Call Dial Forced
Sending Start Time.
Assign a unique Class of Service
for Dual OPX telephones only
when using Continued Dialing.
Turn Off or On an extension user
ability to use Continued Dialing,
which allows DTMF signal sending
while talking on extension.
Define the ringing cycle (1~13) for
normal incoming trunk calls (DIL,
ring group, etc.).
Define the ringing cycle (1~13) for
ICM calls.
Define the ringing cycle (1~13) for
DID calls.
Assigned Data
1
0 = Receive all dialed
data, before sending
(All)
1 = Direct through out
(Direct)
(default = 0)
0~64800 (seconds)
(default = 3)
0 = Normal Mode
1 = Extended Mode1
2 = Extended Mode2
(default = 0)
0~64800 seconds
(default = 5)
0~64800 seconds
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
Ringing Cycle = 1~13
(default = 2)
Ringing Cycle = 1~13
(default = 12)
Ringing Cycle = 1~13
(default = 8)
Issue 8.01
Level
2 3










2 - 1207