NEC Univerge SV8100 Features And Specifications Manual page 1299

UNIVERGE SV8100
Single Line Telephones, Analog 500/2500 Sets
Trunk Group Routing
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit
Setup
11-10-04 Service Code Setup (for System
Administrator) – Storing
Common Speed Dialing
Numbers
11-10-05 Service Code Setup (for System
Administrator) – Storing Group
Speed Dialing Numbers
11-11-39 Service Code Setup (for Setup/
Entry Operation) – Station Speed
Dial Number Entry
11-12-10 Service Code Setup (for Service
Access) – Station Speed Dialing
Speed Dial – System/Group/Station
Description/Comments
If dial tone detection is enabled,
allocate at least one circuit for dial
tone detection (Type 0 or 2).
Customize the service code used
for storing Common Speed Dialing
Numbers.
Customize the service code used
for storing group speed dialing
numbers.
Customize the service code used
for entering station speed dial
numbers.
Assign Service code used for
accessing System Speed Dial bins
#
(default 2).
Assigned Data
1
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available.
MLT
(default = 753)
MLT
(default = 754)
MLT, SLT
(default = 755)
MLT, SLT
#
(default = 2)
Issue 8.01
Level
2 3





2 - 1271