NEC Univerge SV8100 Features And Specifications Manual page 1005

UNIVERGE SV8100
Program 15-22-02 set to 0 or 1 (DTMF Confirmation Required):
The caller is retrieved by the UNIVERGE SV8100 and follows the no-answer programming (ring
another extensions, forward to UNIVERGE SV8100 voice mail, etc.)
Program 15-22-02 set to 2 (No DTMF Confirmation Required):
The caller is forwarded to the external extension voice mail, if available.
Outside Party Dialing the Mobile Extension
1. Dial the DID or DIL telephone number for the Mobile Extension.
System programming (DID=22-11-01 or DIL=22-07-01) must be defined.
If the Mobile Extension is turned off, incoming callers hear a message indicating the user is not
available. The setting in the DTMF Confirmation programming (Program 15-22-02) determines
how the call is handled.
Program 15-22-02 set to 0 or 1 (DTMF Confirmation Required):
The caller is retrieved by the SV8100 and follows the no-answer programming (ring another
extension, forward to SV8100 voice mail, etc.)
Program 15-22-02 set to 2 (No DTMF Confirmation Required):
The caller is forwarded to the external extension voice mail, if available.
Placing a Call from the Mobile Extension
1. Dial the DID or DIL telephone number for the Mobile Extension.
If the Caller ID of the Mobile Extension matches the Speed Dial bin entry (Program 13-04 and
15-22), internal dial tone is heard by the Mobile Extension user.
2. Dial the desired Intercom number or dial the trunk access code to place an outgoing call.
Answering a Call on the Mobile Extension
1. Answer the ringing call.
2. If Program 15-22-02 is set to 0 or 1, the Mobile Extension user hears Music on Hold/ring tone.
Press * (within 10 seconds) to answer the call.
This step is required when using analog trunks for the Mobile Extension feature.
Sending a Flash from the Mobile Extension
1. While on a conversation, a hook flash is returned by dialing *# from the Mobile Extension.
Internal Dial Tone After Hang Up
1. When a call is finished, disconnect the call and receive internal dial tone by dialing *0.
Placing/Retrieving a Call on Hold from the Mobile Extension
1. While on a call, press * #.
2. To retrieve the held call, with system dial tone, press * #.
Mobile Extension
Issue 8.01
2 - 977