Station Relocation - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Description
Station Relocation allows a station to be moved from one location to another, without having to
reprogram the station data. The station features and extension number are the same after it is moved to
the new location.
Conditions
This feature can be used to swap or relocate multiline and single line terminals.

Single line includes SLT adaptors.

The destination extension must be idle. If the station is not idle, busy tone is heard.

If the Extension Swap service code is dialed from an extension that does not have an

extension swap password programmed, busy tone is heard.
If the Extension Swap service code is dialed from an extension whose Class of Service

does not allow Extension Data Swap, busy tone is heard.
If the destination extension entered is not a valid extension, busy tone is heard.

The following user setting data is relocated with the extension. All other user setting data is

either not relocated or cleared.
DND

Call Forwarding

Memo Dial

Last Number Dial History

Saved Number Dial

Incoming History

MIC LED Status

VM MW LED Status

When using Set Relocation, and a terminal is re-located from one physical system to

another physical system, route programming must be made accordingly for 911 calls.
Refer to the Programming section in this feature for system programs that are swapped.

Station Relocation

Station Relocation
Issue 8.01
2 - 1325