NEC Univerge SV8100 Features And Specifications Manual page 1003

UNIVERGE SV8100
Callback to Cell Phone
Program
Program Name
Number
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
13-04-03 Speed Dialing Number and Name
– Transfer Mode
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
14-01-30 Basic Trunk Data Setup –
Flexible Ringing by Caller ID
15-22-01 Mobile Extension Setup – Mobile
Extension Target Setup
15-22-03 Mobile Extension Setup – Trunk
Access Code
Mobile Extension
Description/Comments
Enter the Common and Group
Speed Dialing numbers and
names which are to be used for
Trunk-to-Trunk Forwarding.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
Set up the transfer destination
number or the IRG number.
Enable/Disable Flexible ringing on
each Trunk port base.
For each Mobile Extension
number, select the Abbreviated
Dial bin number to be associated
with it.
Select whether the Normal or
Individual Trunk access is used
when making the call to the mobile
number.
Assigned Data
1
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)

@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
0 = Not Used
1 = Internal Dial

2 = Incoming Ring
Group (IRG)
(default = 0)
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
#
1~9, 0, , , P, R, @

(Maximum 24
Characters)
2 = Incoming Ring

Group
0~100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
0 = Disable

1 = Enable
(default = 1)
0~1999
(0 = No setting

1~1999 = target of
mobile extension)
(default = 0)
0 = Use normal trunk
access code (Program
11-09-01)

1 = Use individual trunk
access code (Program
11-09-02)
(default = 0)
Issue 8.01
Level
2 3
2 - 975