NEC Univerge SV8100 Features And Specifications Manual page 1150

Issue 8.01
If the feature key is not listed below, the LCD shows ALL-BLANK. (Program 15-07-01 Line

Key Assign).
Function
Number
00
01
02
03
04
05
07
10
11
12
13
14
15
If a key is programmed as a DSS/One-Touch key for a station that is set for Call Forward All Calls or Do

Not Disturb, the DSS/One-Touch key flashes.
Refer to the UNIVERGE SV8100 Programming Manual for a complete list of Function Numbers.

One-Touch keys programmed for Park Hold Service Code cannot be used to park calls

without using Hold or Transfer.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered

as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ can be entered in the dial string of a DSS/One Touch button. The @ only applies to

ISDN and Intercom calls. When using the @, the system waits for the destination to answer
(answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom

calls, or after the @ for ISDN calls.
DSS/One-Touch keys can be used for one-touch transfer.

DSS keys can distinguish whether the telephone is set for DND/Call Forward All Calls of if

the telephone is off-hook.
When a Ring Group call rings a station, a BLF Indication for this station shows idle or busy

based on Class of Service option (20-13-49).
All features programmed under one touch keys are still subject to class of service

restrictions.
2 - 1122
Function
None
DSS/One-Touch
Microphone Key (ON/OFF)
DND Key
BGM (ON/OFF)
Headset
Conference Key
Call Forward – Immediate
Call Forward – Busy
Call Forward – No Answer
Call Forward – Busy/No Answer
Call Forward – Both Ring
Follow Me
Display
[All Blank]
DSS (xxxxxxxx xxxxxxxx = Extension Number)
MIC
DND
BGM
HSET
CONF
CFA
CFB
CFNA
CFBNA
CFBOTH
FLWME
Programmable Function Keys
UNIVERGE SV8100