Table of Contents
Advertisement
(config-if)# exit
Sets the LACP port priority level of port 0/1 to
(4) Setting the LACPDU sending interval
Points to note
Set the interval at which the remote device sends LACPDUs to the Switch. The
Switch receives LACPDUs at the set interval.
For the LACPDU sending interval, set
The default is
timeout earlier if a link fault occurs, shortening the length of the communication
stoppage.
Command examples
1.
(config)# interface port-channel 3
(config-if)# channel-group periodic-timer short
(config-if)# exit
Sets the LACPDU sending interval of channel group 3 to
Notes
Although fault detection is earlier with the
LACPDU traffic adds to the burden of the link aggregation program. If a timeout
message is output or if communication often stops temporarily by setting
second), use either the default value of
14.2.4 Configuration of a port channel interface
A port channel interface is used to set the functions that operate on a channel group.
A port channel interface is set up manually by using configuration commands or generated
automatically when the
Ethernet interface configuration mode.
(1) Relationship between the port channel and Ethernet interfaces
A port channel interface is used to configure the functionality that operates on a channel
group. The same functionality can also be configured from the Ethernet interface in
configuration mode. Some of the commands provided by these interfaces are related as
follows:
The settings of the related commands of the port channel and Ethernet interfaces
must match.
If the
interface when a port channel interface has not been set up, the port channel
interface is automatically generated. At this time, related commands must not be
specified in the Ethernet interface in which the
command is specified.
If the
interface when a port channel interface has already been set up, the settings of the
related commands must match.
If a related command is set by using a port channel interface, the setting is also
applied to a related command registered in an Ethernet interface by using the
channel-group mode
The table below describes the commands related to port channel interface.
long
(30 seconds). Setting
channel-group mode
channel-group mode
configuration command is specified by using an Ethernet
channel-group mode
configuration command is specified by using an Ethernet
configuration command.
100
.
long
(30 seconds) or
short
makes it possible to detect a
short
short
setting (1 second), the increased
long
(30 seconds) or static mode.
configuration command is executed in
channel-group mode
14 Link Aggregation
short
(one second).
(one second).
short
(1
configuration
221
Advertisement
Table of Contents
