Configuration Of Gigabitethernet (Sfp); Setting 100Base-Fx Ports [Ax1250S]; Setting A 1000Base-X Port - Alaxala AX2200S Series Configuration Manual

Table of Contents

Advertisement

13.9 Configuration of Gigabitethernet (SFP)

13.9.1 Setting 100BASE-FX ports [AX1250S]

For a port for which 100BASE-FX is used, specify the transmission speed, full duplex, and
media type.
Points to note
Configure as follows: transmission speed of 100 Mbit/s, full duplex, and a media type
of SFP
Command examples
1.
(config)# interface gigabitethernet 0/26
(config-if)# shutdown
(config-if)# media-type sfp
(config-if)# speed 100
(config-if)# duplex full
Sets the media type to
device at a transmission speed of 100 Mbit/s in full-duplex mode.
2.
(config-if)# no shutdown
(config-if)# exit
Notes
When you use 100BASE-FX, make sure that you configure the above settings. (Flow
control is disabled when

13.9.2 Setting a 1000BASE-X port

(1) Setting the transmission speed and duplex mode
You can set the transmission speed and duplex mode used for communication between the
Switch and a remote device. By default, the transmission speed and duplex mode are
determined automatically by auto-negotiation. To change to the transmission speed and
duplex mode that corresponds to the remote device, first specify
and then change the setting. For details about media types, see 13.7.5 Setting the media
type [AX1250S] [AX1240S]. [AX1250S] [AX1240S]
Points to note
The Switches connect to remote devices by auto-negotiation. Because
auto-negotiation is the default connection method for the Switch, you do not need to
set transmission speed and duplex mode. If auto-negotiation is not used, set the
transmission speed to 1000 Mbit/s and the duplex mode to full duplex.
Command examples
1.
(config)# interface gigabitethernet 0/25
(config-if)# shutdown
(config-if)# media-type sfp
(config-if)# speed 1000
(config-if)# duplex full
Sets the media type to
remote device at a transmission speed of 1000 Mbit/s in full-duplex mode.
and configures a switch so that it connects to the remote
sfp
duplex
has not been set or has been set to
sfp
, and configures the switch so that it connects to the
13 Ethernet
auto
.)
sfp
for the media type,
195

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ax1250s seriesAx1240s series

Table of Contents