13 Ethernet
13.2.2 Setting Ethernet interface ports [AX2200S]
Points to note
To configure Ethernet, specify the interface port number, and then move to config-if
mode to set up the information.
Command examples
1.
(config)# interface gigabitethernet 0/1
(config-if)# exit
Specifies the setting for the Gigabitethernet port 0/1.
In the setting examples below,
switches, however, use
13.2.3 Setting Ethernet interface ports [AX1250S] [AX1240S]
Points to note
To configure Ethernet, specify the interface port number, and then move to config-if
mode to set up the information.
Command examples
1.
(config)# interface fastethernet 0/1
(config-if)# exit
Specifies the setting for Fastethernet port 0/1.
2.
(config)# interface gigabitethernet 0/25
(config-if)# exit
Specifies the setting for Gigabitethernet port 0/25.
13.2.4 Configuring multiple ports at one time
Points to note
When Ethernet is configured, the same information sometimes needs to be set for
multiple ports. In such cases, the same information can be set for the ports at the
same time by using a range specification.
Command examples
1.
(config)# interface range fastethernet 0/1-10,0/15-20
Specifies the settings for ports 0/1 to 0/10, and 0/15 to 0/20.
2.
(config-if-range)# *****
(config-if-range)# exit
Performs the same configuration for all the ports.
160
interface fastethernet
interface gigabitethernet
is specified. For AX2200S series
instead.