Alaxala AX2200S Series Configuration Manual page 227

Table 13-30 Operation commands and the effect on power supply control
Target Port setting
Switch None
Port no shutdown
Other than
inline never
All other cases
Legend:
Y: Affected.
N: Not affected.
--: Not affected because the command is not supported.
(2) Trigger of transition of the port status
Transitions of the status of the ports displayed by the
command are triggered by the setting of configuration, execution of operation commands,
or a change in the status of the power supply.

off: Power is not being supplied.

on: Power is being supplied.

denied

faulty

inact
The following table describes the port status and the triggers of status transition.
Operation
commands
Not supported
inactivate interface
power
activate interface
inactivate power
inline
activate power inline
inactivate interface
activate interface
inactivate power
inline
activate power inline
: Power is not being supplied because there is not enough power.
: Power cannot be supplied to the connected device.
: The supply of power has been stopped by an operation command.
Effect on power Remarks
supply control
--
N
N
Y Link-down due to power
supply stoppage
Y Link-up due to resumption
of power supply
N Execution of operation
commands has no affect,
and power supply control is
N
performed according to the
configuration.
N
(See Table 13-29.)
N
show power inline operation
13 Ethernet
205