Table of Contents
Advertisement
Sets
shutdown
can be removed safely from the channel group.
2.
(config-if)# no channel-group
(config-if)# exit
Deletes the channel group settings from port 0/1.
(2) Deleting an entire channel group
Points to note
You can delete an entire channel group. Because the ports in the deleted channel
group can operate independently,
communication loop.
An entire channel group is deleted by deleting the
command. After this deletion, the
automatically deleted from each port registered in the channel group. Be careful
when using the ports for another purpose because the related commands that were
set for the ports by using the
group was deleted remain after the removal. (For details about the related
commands, see Table 14-4 Related commands for a port channel interface.)
Command examples
1.
(config)# interface range fastethernet 0/1-2
(config-if-range)# shutdown
(config-if-range)# exit
Sets
shutdown
status so that the entire channel group can be deleted safely.
2.
(config)# no interface port-channel 3
Deletes channel group 3. The
ports 0/1 and 0/2 are also deleted automatically.
for port 0/1 to place the port in the link-down status so that the port
shutdown
channel-group mode
interface port-channel
for all ports in the channel group to place these ports in the link-down
channel-group mode
14 Link Aggregation
is set beforehand to prevent a
interface port-channel
configuration command is
command before the port
configuration commands set for
225
Advertisement
Table of Contents
