Alaxala AX2200S Series Configuration Manual page 79

(d) Restrictions on the number of characters for a command or parameter displayed in
Help
If a command or parameter has 24 or more characters, only the beginning 24 characters
are displayed in Help.
Figure 5-14 Example of when the number of characters displayed in Help is restricted
(config)# switchport-backup
startup-active-port-sel - Specify the mode of active port selection pattern at
(config)#
In the above example,
characters, is supposed to be displayed as Help for the
but only startup-active-port-sel
omitted.
(e) Restrictions on the Help display and command line completion of configuration
commands deny, permit, and qos
The Help display and command line completion of the configuration commands
permit (except for

When the input format of a command is shown in the Help display
If the parameter
subsequent parameters always shows the input format of the relevant command as
shown in the following figure.
Figure 5-15 Example of when the input format is shown in the Help display (example for ip
access-list extended)
(config-ext-nacl)# permit
<protocol>
(config-ext-nacl)# permit ip
<PARAMs:input format>

When <cr>
The Help display normally shows
configuration commands
input is incomplete. If you press the Enter key according to the
the input is incomplete, an error occurs. Re-enter the relevant command. Refer to
the Configuration Command Reference and Operation Command Reference
manuals.
startup
startup-active-port-selection
is displayed and the subsequent characters are
ip access-list standard
<Src IPv4> or <Src MAC>
- 0-255,ah,esp,gre,icmp,igmp,ip,ipinip,ospf,pcp,pim,sct
p,tcp,tunnel,udp,vrrp
- [<Seq>] permit <Protocol> {<Src IPv4> <Src IPv4 wildc
ard> | host <Src IPv4> | any} [*1] {<Dst IPv4> <Dst I
Pv4 wildcard> | host <Dst IPv4> | any} [*2] [*3] {[to
s <TOS>] [precedence <Precedence>] | dscp <DSCP>} [vl
an <VLAN ID>] [user-priority <Priority>]
*1:for TCP/UDP - eq <Src port>
<Dst port>
n] [urg]
is shown in the Help display
<cr>
deny , permit
, which is more than 24
switchport-backup
), and qos are restricted as follows:
is specified, the Help display for the
*3:for TCP - [ack] [fin] [psh] [rst] [sy
when the input is complete. However, for the
, or qos , <cr> might be shown even when the
5 Command Operations
command,
deny ,
NOTE:
*2:for TCP/UDP - eq
<cr> display when
57