Table of Contents
Advertisement
6.4.2 Starting configuration editing (configure command and configure terminal
command)
To edit a configuration, first execute the
Then enter the configure command or configure terminal command. The prompt changes
to
(config)#
example of starting editing of a running configuration.
Figure 6-4 Example of starting editing of a running configuration
enable
# configure
(config)#
1.
Execute the
2.
Start editing the running configuration.
6.4.3 Displaying and checking configuration entries (show command)
(1) Displaying and checking the startup configuration file or running configuration
You can display and check the running configuration or startup configuration file by using
the
show running-config
mode. The following figure shows an example of displaying a running configuration.
Figure 6-5 Example of displaying a running configuration
# show running-config
#configuration list for XXXXXXX-XXXXX
!
vlan 1
name "VLAN0001"
!
vlan 100
state active
!
vlan 200
state active
!
spanning-tree mode pvst
!
interface fastethernet 0/1
switchport mode access
switchport access vlan 100
!
interface fastethernet 0/2
switchport mode access
switchport access vlan 200
!
:
:
#
1.
Displays the running configuration.
, allowing you to edit the running configuration. The following figure shows an
...1
...2
enable
command to enter administrator mode.
or
show startup-config
enable
command to switch to administrator mode.
operation command in administrator
...1
6 Configuration
67
Advertisement
Table of Contents
