Alaxala AX2200S Series Configuration Manual page 144

10 Device Management
on the console terminal to collect device status information, and then restore the Switch.
When executing the
is disabled, only display to the console terminal is permitted. Therefore, do not specify the
ramdisk
by executing this command, use the capture function of the console terminal to collect the
information.
Note the following when automatic restoration is disabled on the Switch:

Do not update software while automatic restoration is disabled. Restore the Switch,
and then start updating.

You might not be able to execute commands normally while automatic restoration is
disabled.
(b) Restoration of the Switch
Perform the following to restore the Switch from the status of automatic restoration being
disabled:

Restart the Switch by turning off and on the power, or by pressing the RESET button.

If software is hung up while automatic restoration is disabled, reset the hardware to
restart the Switch.
122
show tech-support
or page option in this command. For information displayed on the console screen
operation command while automatic restoration