Table of Contents
Advertisement
Moves from configuration command mode to administrator mode, and saves the
settings.
3.
@# reload
Restart OK? (y/n): y
After the configuration setting is saved,
reload
Notes
When this command is set or deleted, the new setting is applied after the Switch is
restarted.
13.11.5 Allocating power that can be supplied to each port
Power to be supplied to each port can be set either based on its class or manually. The
initial setting is based on its class.
Points to note
If you connect a class 4 PD and its power consumption is lower than the maximum
power consumption of 30.0 W, set the power to be supplied, adding a margin to the
maximum power consumption of the PD.
In this example, you set an arbitrary value for the power supplied to port 0/20.
Command examples
1.
(config)# interface fastethernet 0/20
(config-if)# power inline allocation limit 20000
Sets 20000 mW (20 W) for the power to be supplied to port 0/20.
2.
(config-if)# exit
operation command to restart the Switch.
@
is displayed in front of the prompt. Use the
13 Ethernet
211
Advertisement
Table of Contents
