Table of Contents
Advertisement
13.11 Configuration of PoE [AX2200S] [AX1240S]
13.11.1 List of configuration commands
The following table lists and describes the commands used to configure PoE.
Table 13-32 List of configuration commands
Command name
power inline
power inline priority-control disable
power inline allocation
power inline system-allocation
[AX2200S]
13.11.2 Setting the maximum amount of power that can be supplied for system 1
[AX2200S]
An AX2200S series switch has two systems, system 1 and system 2, and you can set the
maximum amount of power that can be supplied for the whole of system 1 in the
configuration.
The amount of power allocated to the whole of system 2 is obtained by subtracting the
value allocated to system 1 from the value 370.0 W (for the entire Switch).
Points to note
You can allocate the maximum power supply of 240.0 W in order to supply 60.0 W for
system 1 as follows.
Command examples
1.
(config)# power inline system-allocation limit 240000
Please execute the reload command after save,
because this command becomes effective after reboot.
Sets 240.0 W as the maximum amount of power that can be supplied to the whole of
system 1. A message appears that asks you to save the settings and restart the
device.
2.
(config)# exit
# copy running-config startup-config
Do you wish to copy from running-config to startup-config? (y/n): y
Moves from configuration command mode to administrator mode, and saves the
settings.
3.
@# reload
Restart OK? (y/n): y
After the configuration setting is saved,
reload
Description
Sets the port priority.
Assigns priority to a powered port.
Sets power allocation for each port either based on its class or
manually.
Sets the maximum amount of power that can be supplied for
system 1 manually.
operation command to restart the Switch.
@
is displayed in front of the prompt. Use the
13 Ethernet
209
Advertisement
Table of Contents
