Table of Contents
Advertisement
6 Configuration
Figure 6-21 Copying a backup configuration file on the Switch to a memory card (copy
> enable
# copy startup-config ramdisk backup.cnf
# copy ramdisk backup.cnf mc backup.cnf
#
1.
Copy the startup configuration file to the RAMDISK.
2.
Copy the backup configuration file on the RAMDISK to a memory card.
6.5.3 Notes on applying a backup configuration file
When you copy the backup configuration file to the startup configuration file by using the
copy
operation command, the configuration cannot be directly applied to the running
configuration. Restarting the device by turning it off and then on again, or by executing the
reload
operation command is necessary. Be careful if you are logged in from a remote
terminal.
If the contents of the backup configuration file are inconsistent with the Switch's actual
configuration, amend the file and then use the
74
command)
copy
operation command.
...1
...2
Advertisement
Table of Contents
