Configuration; List Of Configuration Commands; Flow Of Ring Protocol Settings - Alaxala AX2200S Series Configuration Manual

21 Settings and Operation for the Ring Protocol

21.1 Configuration

To use the Ring Protocol functionality,
vlan-group
nodes.

21.1.1 List of configuration commands

The following table describes the configuration commands used to configure the Ring
Protocol on the Switch.
Table 21-1 List of configuration commands
Command name
axrp
axrp vlan-mapping
axrp-ring-port
control-vlan
disable
forwarding-shift-time
mode
multi-fault-detection mode
multi-fault-detection vlan
name
vlan-group

21.1.2 Flow of Ring Protocol settings

Normal operation of the Ring Protocol functionality requires settings that match the
configuration. The flow of these settings is as follows.
(1) Stopping Spanning Tree Protocols
Stop Spanning Tree Protocols before using the Ring Protocol. For details about stopping
Spanning Trees, see 19. Spanning Tree Protocol.
(2) Performing settings common to the Ring Protocol
Perform ring configuration settings and common settings that do not depend on the
placement of the Switch within a ring.

Ring ID

Control VLAN

VLAN mapping

VLAN group
386
, and axrp-ring-port
Description
Sets the ring ID.
Sets the VLAN mapping and VLANs participating in the mapping.
Sets the ring port.
Sets the VLAN to be used as a control VLAN.
Disables the Ring Protocol functionality.
Sets the reception hold time for flush control frames.
Sets the operating mode for a ring.
Sets the monitoring mode for multi-fault monitoring.
Sets the VLAN used as the multi-fault monitoring VLAN.
Sets the name for identifying a ring.
Sets the VLAN group for which to run the Ring Protocol functionality, and
the VLAN mapping ID.
axrp , axrp vlan-mapping
need to be set. Set the appropriate configuration for all
, mode , control-vlan ,