Alaxala AX2200S Series Configuration Manual page 59

limits of the total number of CFM ports and total number of remote MEPs change if
you change the CCM transmission interval. The following table describes the
capacity limits for total CFM ports and total remote MEPs according to the set CCM
transmission interval.
Table 3-38 Capacity limits based on CCM transmission interval
Model
All models
#3
Total number of remote MEPs is the sum of MEPs on other devices. This affects the
CCM receiving performance from MEPs. You can check the total number of remote
MEPs using the
Table 3-39 Capacity limits for CFM physical ports and channel groups
Model
All models
#
Multiple MEPs or MIPs can be assigned to the same port. Each channel group is
counted as one port.
Table 3-40 Capacity limits for the CFM database
Model
All models
#
Information for a maximum of 256 devices can be retained per route. If information
for 256 devices is stored per route, the database can store information for a
maximum of four routes (1024 / 256 devices = 4 routes).
Interval for sending
CCMs
1 minute or longer
10 seconds
1 seconds
show cfm remote-mep
Total number of physical ports and channel groups to which MEP or MIP can
#
be assigned
8/device
Number of MEP CCM
database entries
63/MEP
Total number of CFM
ports
256/device
100/device
50/device
operation command.
Number of MIP CCM
database entries
2048/device
3 Capacity Limit
Total number of remote
MEPs
2016/device
640/device
64/device
Number of linktrace
#
database entries
1024/device
256/route
37