Table of Contents
Advertisement
4.3 Login and logout
This section describes login and logout procedures.
(1) Login
When a switch starts, a login window appears. Enter your user ID and password. If
authentication is successful, a command prompt appears. If authentication fails, the
message
login window.
For the initial deployment, you can log in with the user ID
password.
Figure 4-4 Login window
login: operator
Password:
Copyright (c) 2006-2012 ALAXALA Networks Corporation. All rights reserved.
>
1.
Password:
If a password has been set and you enter the password, the character string of the
entered password is not displayed.
2.
The command prompt appears.
(2) Logout
To log out after completing operations via the CLI, execute the
exit
command. The figure below shows the logout window.
Figure 4-5 Logout window
> logout
login:
(3) Auto-logout
You are automatically logged out if there is no key input for a set duration (default: 30
minutes). You can change the auto-logout time using the
command.
appears and you cannot log in. The figure below shows the
Login incorrect
is displayed only when a password has been set.
4 Login Procedures
operator
, without needing a
...1
...2
logout
command or the
operation
set exec-timeout
45
Advertisement
Table of Contents
