13.3 Operations common to all Ethernet interfaces
13.3.1 List of operation commands
The following table describes the operation commands common to Ethernet.
Table 13-4 List of operation commands
Command name
show interfaces
show port
clear counters
inactivate
activate
13.3.2 Checking the Ethernet operating status
(1) Checking the operating status of all Ethernet ports
You can use the
the Switch. If you want to use an Ethernet port, confirm that
the port in the execution results.
The following figure shows an example of the results of executing the
command.
Figure 13-5 Example of the results of executing the command that displays the status of all
> show port
Date 2008/11/13 11:40:21 UTC
Port Counts: 26
Port
Name
0/1
fastether0/1
0/2
fastether0/2
0/3
fastether0/3
0/4
fastether0/4
0/5
fastether0/5
0/6
fastether0/6
:
:
Description
Displays Ethernet information.
Displays Ethernet information in list format.
Clears the Ethernet statistics counters.
Changes the status of an Ethernet port from active to inactive.
Changes the status of an Ethernet port from inactive to active.
show port
operation command to check the status of all Ethernet ports on
Ethernet ports on the Switch
Status
Speed
up
100BASE-TX
up
100BASE-TX
up
100BASE-TX
up
100BASE-TX
down
-
down
-
up
is displayed for
show port
Duplex
FCtl FrLen
full(auto) off
1518
full(auto) off
1518
full(auto) off
1518
full(auto) off
1518
-
-
-
-
-
-
13 Ethernet
Status
of
operation
ChGr/Status
8/up
8/up
8/up
8/up
8/up
8/up
165