Index - Alaxala AX2200S Series Configuration Manual

Index

A
abbreviated-command execution, 51
access ports and trunk ports, 261
adding, changing, and deleting configuration
entries, 69
aging and MAC address learning, 242
allocating power supplied by PoE [AX1240S],
200
allocating power that can be supplied to each
port, 211
allocating the power supplied by PoE
[AX2200S], 197
application functionality and scope of RADIUS
authentication, 86
assigning an IP address to the Switch, 77
authentication using RADIUS, 88
automatic MDIX functionality settings, 162, 173,
184
automatic SFP recognition (selection of media
type) [AX1250S] [AX1240S], 182
B
backing up and restoring device information,
113
basic configuration (when DHCP snooping is
performed via a Layer 3 switch), 420
basic configuration for the multi-fault monitoring
functionality, 373
basic Ring Protocol principles, 356
BPDU filter, 340
C
capacity limit, 19
changing blocked ports, 291
changing the login user, 83
checking ARP information, 461
checking DHCP snooping, 429
checking dynamic ARP inspection, 430
checking IGMP snooping, 450
checking MLD snooping, 454
checking PVST+ statuses, 315
checking Ring Protocol statuses, 395
checking the Ethernet operating status, 165
checking the MAC address learning count, 248
checking the Multiple Spanning Tree status,
337
checking the PoE power supply status, 212
checking the reachability to the destination, 460
checking the route to the destination, 461
checking the routing table, 461
checking the Single Spanning Tree status, 323
checking the software version, 109
checking the status of common Spanning Tree
functionality, 349
checking the status of MAC address learning,
248
467
checking the switch status, 110
checking the time, 105
checking the up/down state of an IPv4 interface,
460
checking VLAN extended functionality, 292
checking VLAN status, 281
clearing the MAC address table, 243
command input mode, 48
command operations, 47
commands
operations, 47
compatibility between AX2200S and AX1200S
series switches, 115
compatibility between Layer 2 switch
functionality and other functionality, 236
compatibility of device information between
AX1250S series switches and AX1240S
series switches, 117
compatibility of device information between
AX1250S/AX1240S series switches and
AX1230S series switches, 118
compatibility of input commands between
AX1250S/AX1240S series switches and
AX1230S series switches, 115
compatibility with other Spanning Tree
Protocols, 329
configuration, 61
configuration at startup, 62
configuration common to all Ethernet interfaces,
159
configuration components for Spanning Tree
topologies, 299
configuration during operation, 62
configuration editing procedures, 66
configuration of a port channel interface, 221
configuration of DHCP snooping, 419
configuration of Fastethernet [AX1250S]
[AX1240S], 172
configuration of Gigabitethernet (RJ45), 183,
195
configuration of IGMP snooping, 448
configuration of LACP link aggregation, 220
configuration of MAC VLANs, 275
configuration of MLD snooping, 452
configuration of Multiple Spanning Tree, 331
configuration of PoE [AX2200S] [AX1240S],
209
configuration of protocol VLANs, 267
configuration of Single Spanning Tree, 318
configuration of the basic link aggregation
functionality, 219
configuration of the basic VLAN functionality,
258
configuration of the common Spanning Tree
functionality, 345
configuration of the inter-port relay blocking
functionality, 290
configuration of the link aggregation extended
functionality, 228
configuration of the Spanning Tree operating