Table of Contents
Advertisement
7 Remote Login
(config)#
Switches to interface configuration mode for VLAN ID 100. Sets IPv4 address
192.168.1.1 and subnet mask 255.255.255.0 for VLAN ID 100.
7.2.3 Permitting login by using the Telnet protocol
Points to note
The switch's IP address must be assigned before you can use this procedure.
Configure the Switch so that remote login is allowed via Telnet.
If remote login has not been configured, you can log in only from the console.
Command examples
1.
(config)# line vty 0 1
(config-line)# exit
Permits remote access to the Switch from a remote operation terminal by using the
Telnet protocol. Limits the number of concurrent remote logins to a maximum of two
users.
7.2.4 Permitting login by using FTP
Points to note
The switch's IP address must be assigned before you can use this procedure.
Configure the Switch so that remote access is allowed via FTP.
If the Switch is not configured in this manner, users cannot access the Switch by
using FTP.
Command examples
1.
(config)# ftp-server
Permits remote access to the Switch from a remote operation terminal by using FTP.
78
Advertisement
Table of Contents
