11 Power Saving Functionality
11.2.2 LED behavior setting
(1) LED behavior setting
Points to note
In this setting, you set a Switch's LED behavior to power saving brightness.
Command examples
1.
(config)# system port-led economy
Sets the Switch's LED behavior to power saving brightness.
Notes
Power saving brightness is not supported by AX2200S. Set normal brightness or Off
instead.
(2) Setting a trigger for LED automatic operation
You can make LED behavior automatically change, adding a trigger for automatic operation
to the LED setting.
Points to note
In this setting, you set the console port and physical ports (link-up or link-down), and
a memory card (insert or remove) as triggers for automatic LED operation on the
Switch.
Command examples
1.
(config)# system port-led enable
Sets the LED behavior to normal brightness.
2.
(config)# system port-led trigger console
(config)# system port-led trigger interface 0/1,0/20
(config)# system port-led trigger mc
Sets the console port and ports 0/1 and 0/20 (link-up or link-down), and a memory
card (insert or remove).
11.2.3 Setting power saving for ports in link-down status
Points to note
In this setting, you set the power saving for ports in the link-down status.
Command examples
1.
(config)# power-control port cool-standby
Sets power saving for link-down for all ports.
11.2.4 Setting cooling fan control (Semi-fanless operation) [AX1240S]
Points to note
This setting lets you configure operation so that the fans stop when internal
temperature monitoring determines that forcible cooling is unnecessary.
Command examples
1.
(config)# system fan-control
Configures the setting so that the fans stop at a temperature where forcible cooling is
unnecessary.
144