Configuring Ring Ids; Setting Control Vlans - Alaxala AX2200S Series Configuration Manual

(3) Setting the mode and port
Perform ring configuration settings and settings related to the placement of the Switch
within a ring. If the combination of settings contains a conflict, the Ring Protocol
functionality will not operate properly.

Mode

Ring port
(4) Setting various parameters
The Ring Protocol functionality runs using the initial values if the following configurations
are not set. To change these values, set them using commands.

Disabling functionality

Reception hold time for flush control frames

21.1.3 Configuring ring IDs

Points to note
The ring ID can be set. The same ring ID needs to be set for all switches belonging
to the same ring.
Command examples
1. (config)# axrp 1
Sets the ring ID to 1.

21.1.4 Setting control VLANs

(1) Setting control VLANs
Points to note
You can specify the VLAN to be used as the control VLAN. Note that the following
VLANs cannot be set:



Command examples
1.
(config)# axrp 1
Switches to axrp configuration mode for ring ID 1.
2. (config-axrp)# control-vlan 2
(config-axrp)# exit
Specifies VLAN 2 as the control VLAN.
(2) Setting the forwarding transition time for control VLANs
Points to note
You can set the forwarding transition time for the control VLAN of a transit node for
when the Ring Protocol is in the initial status. Set the forwarding transition time for
the control VLAN of a transit node (value set for the
parameter) to a value greater than that set for the hold time for health check frames
on the master node (value set by the
command). However, set a value smaller than that set for the reception hold time for
flush control frames (value set for the
VLANs used as the data transfer VLAN
VLANs that have VLAN IDs used for other rings
Default VLAN (VLAN = 1)
21 Settings and Operation for the Ring Protocol
forwarding-delay-time
health-check holdtime
forwarding-shift-time
configuration
configuration
387