Led Behavior - Alaxala AX2200S Series Configuration Manual

#3
Normal brightness and Off are supported. Power saving brightness is not supported.
In this chapter, ports are referred as follows:

10BASE-T or 100BASE-TX port: Fastethernet port

10BBASE-T, 100BASE-TX, or 1000BASE-T: Gigabitethernet port

100BASE-FX [AX1250S] or 1000BASE-X port: SFP port

11.1.2 LED behavior

This configuration function controls LED behavior in two steps for AX2200S series switches
or in three steps for AX1250S and AX1240S series switches. Also, LED behavior can be
automatically changed if you set a trigger for automatic operation in the Switch's
configuration.
(1) LED behaviors
Use the system port-led
behaviors:

Normal brightness: The LEDs operate at normal brightness.

Power saving brightness: The LEDs operate at a lower brightness level than normal.

Off: The LEDs of all ports are turned off. (ST1 and ACC also operate in a state of
reduced brightness.)
The LEDs below can be controlled by the configuration. The PWR LED is not subject to
control. The PWR LED always illuminates with normal brightness. For details about the
LEDs, see the Hardware Instruction Manual.

ST1

ACC

LINK

T/R

1 to 24: AX2230S-24T, AX2230S-24P, AX1250S-24T2C, AX1240S-24T2C and
AX1240S-24P2C

1 to 48: AX1240S-48T2C
The following table describes LED status for each LED behavior setting configured by the
system port-led
Table 11-2 LED status for each configuration setting of LED behavior [AX2200S]
LED type Device status
ST1 Available for
operation
Under
preparation
configuration command to set either of the following LED
configuration command.
LED behavior setting configured by the system port-led
configuration command
Normal brightness (enable)
LED status Brightness
status
Green Regular
Blinking Regular
green
11 Power Saving Functionality
Off (disable)
LED status Brightness
status
Blinking Regular
green at long
intervals
Blinking Regular
green
125