Configuring Network Settings - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide

Configuring Network Settings

Use these menu items to change the current network settings which allow you to access the
library remotely via a web browser.
• IP Stack – Choose IPv4 only, IPv6 only, or IPv4 & IPv6.
• IPv6 Only and Dual Stack IPv4 & IPv6 – Choose Enable Stateless Auto Config
Address (Web User Interface) or Stateless Autoconfig (Operator Control Panel) if
assigned IPv6 IP addresses are desired. To view the assigned IPv6 addresses after
enabling Stateless Auto Config Address, do the following:
Operator Control Panel (IPv6 Only): Monitor > Library > Network
NOTE: If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4 and
• DHCP – (Dynamic Host Configuration Protocol) If this is enabled, your library host
will negotiate the connection with the library. If DHCP is disabled, the following
information is necessary to establish the remote access.
• IP Address – the IP address of the library
• Netmask – the Network Mask address of the library
• IP Stack – the IP Stack manages static IP addresses
• Stateless Autoconfig – allows IPv6 hosts to be configured automatically when
connected to a routed IPv6 network
• Prefix length – the length of the IP address prefix
10400367-001 04/2012
IPv6 IP addresses.
©2012 Overland Storage, Inc.
Configuring Your Library – Operator Control Panel
4-23