Overland Storage NEO 200s Instructions

Add-on/Spare Tape Drive Instructions

This document describes the following procedures for a NEO
200s/400s library from Overland Storage:
• Adding another tape drive to a library.
• Removing and replacing an existing tape drive.
Tape drives are hot-swappable.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.

Register the Add-on Drives

NOTE: If you are only replacing an existing drive, skip to the next
section, "Prepare the Unit."
When installing tape drives to your new library, you must
register them to activate their warranty. This is normally done
at the same time as you register your new library. Technical
and warranty support are not available until this is done:
1. Go to the Overland Storage website
(http://www.overlandstorage.com/).
Selec
2.
t Service & Support > My Products.
3. At the Site Login, enter your e-mail address and
password, and click
4. Click the Manage Products
5. From the Product Selector drop-down list, select the unit
in which you are installing the extra drives.
Add a Component
6. Click
7. Enter the drive information.
8. For each additional drive, click
then repeat Step 7.
9. When ALL disk drives are registered, click
IMPORTANT: Your warranty certificate will be emailed to you.
Follow the instructions included in the email to complete the
registration process.
10400371-001 03/2012
GO .
button.
.
Save & Add Another
Save & Exit
©2012 Overland Storage, Inc.
,
.
NEO 200s/400s
®
SAS
FC
Enter
Enter
Page 1 of 3