Power Cord Attachment - Overland Storage NEO 200S User Manual

NEO 200s/400s User Guide
3. Plug the network Ethernet (management) cable into the Ethernet port on the
back panel of the library. If the Ethernet connection is directly attached to a server or
laptop, a crossover Ethernet cable may be required.
NOTE: It is the customer's responsibility to supply the crossover cable if one is required.
Installing a Fibre Channel Interposer
To install the FC interposer:
1. Connect the host SC fibre cable to the matching side of the interposer.
2. Connect the drive LC fibre side of the interposer to the drive/library.

Power Cord Attachment

WARNING:
before servicing.
AVERTISSEMENT:
d'alimentation avant l'entretien.
1. Remove the protective label from the power receptacle on your library.
2. Plug one end of each power cord into each power supply connector on the back panel
of the library.
3. Plug the other end of each power cord into the nearest properly grounded power
outlet. Use separate power sources for each power supply for redundant power.
4. Turn ON the library using the Power button.
Check the Operator Control Panel display to make sure the library is receiving power.
If it is not, check the power connections and your power source. During the Power-On
Self Test (POST), all four LEDs are illuminated briefly, followed by a flashing Ready
LED. When the initialization sequence is complete, the Home screen is displayed.
10400367-001 04/2012
This device has more than one power cord. Disconnect ALL power supply cords
Cet appareil a plus d'une cordon d'alimentation. Débranchez TOUTES les cordons
©2012 Overland Storage, Inc.
Installing in a Rack
4-7