Overland Storage NEO 200S User Manual page 89

NEO 200s/400s User Guide
• Refresh – to cancel the changes made to the screen.
• Submit – to apply the changes made to the screen.
Configure Library: SNMP
This page shows the current SNMP configuration of the library and allows modification to
the configuration. When a change is requested, a pop-up box checks to confirm the changes.
1. Click SNMP in the left navigation pane, to display the SNMP page.
2. Enter SNMP settings.
NOTE: For more information on SNMP, refer to
• Enabled – Check this box to have SNMP traps sent to a SNMP Management
• Target 1-IP Address – If SNMP traps are enabled, enter an IP address where
• Target 2-IP Address – Enter an optional 2nd IP address where SNMP traps are
• Target 3-IP Address – Enter an optional 3rd IP address where SNMP traps are
• Version – The library offers three versions of the SNMP protocol; v1, v2 and v3.
• Community Name – An SNMP community name is a text string that acts as a
• Audit Logging – If SNMP is enabled and Audit Logging is enabled, the library
Click one of the following:
• Refresh – to cancel the changes made to the screen.
• Submit – to apply the changes made to the screen.
Configure Library: Save/Restore
This page allows the library configuration to be reset to the factory defaults.
10400367-001 04/2012
(SNMP) Messaging" on page
consoles.
SNMP traps are to be sent.
to be sent, or leave as 0.0.0.0.
to be sent, or leave as 0.0.0.0.
Select a version for each Target IP Address.
password to authenticate messages sent between the SNMP remote management
application and the library. Enter your preferred name, or leave as public.
will send SNMP traps to an SNMP Management consoles when the library or tape
drive configuration has changed.
NOTE: This option is only available if the library firmware is 9.00 or higher, and the latest
library MIB file has been added to the SNMP Management console.
©2012 Overland Storage, Inc.
"Simple Network Management Protocol
1-5.
Web User Interface Menus
5-25